HOW TO SHOP

1+91 954 4790 001
2sales@pgpavers.com
3Hurry Up Let Begin

If you still have problems, please let us know, by sending an email to support [ @ ] pgpavers.com . Thank you!

SHOWROOM HOURS

Mon-Fri 9:00AM - 6:00AM
Sat - 9:00AM-5:00PM
Sundays by appointment only!

PAVING INSTALLATION PROCESS

PLANET GREEN PRODUCTS OFFERS GOOD QUALITY, MORE ECONOMY AND BETTER ECO-FRIENDLY PRODUCT RANGE TO MEET YOUR REQUIREMENT

Our product are aesthetically pleasing, easy to maintain & cost effective 

ITEMS REQUIRED FOR LAYING

ALIGNMENT BAR

This could be used for leveling and aligning Pavers or sand

RUBBER HAMMER

Rubber hammer for tapping blocks without damaging the surface

PLATE VIBRATOR

Plate vibrator for final compaction with two to three paves of the plate.

LAYING INSTRUCTIONS

  • Organise all materials like blocks, sand, vibrators and cutter
  • Plan your schedule to avoid delivery of materials before they are needed as they congest the site.
  • Keep the sand with moisture content; do not use sand which is 100% dry.
  • Do not spread sand for larger areas, as it will dry out and reduce the performance.
  • Preferably, use sand of 50mm screeded properly.
  • Pavers should be laid with hand tight to pattern on screeded layer of 50mm sand bed.
  • Complete laying operations like cutting, vibrating and joint filling (with sand) are to be done on the same day. It is important to note that the laying operations should not be done on a piecemeal basis. It should be completed in all aspects on the same day.
  • Joints should be filled with clean dry sand, so that it flows better and fills joints effectively.
  • Edge Curbing: There should be adequate restraint around the perimeter of all paved area to support traffic loads and to prevent the escape of laying course material from beneath the paved surface.
  • It is recommended to provide a slope of 3” on the wider side and 2” on the linear side for every 10’ of laying area.

1step

 

 

 

 

step1

2step

step2

3step

step3

TOP